teh ABS module now gets internal circuit codes and the other modules report a loss of comms with the ABS module. After connecting the ABS module and putting the battery back in, I now get ABS, SRS, Stability Control EPB and the Service Wrench warnings along with codes in all the associated modules. cables were good and motors were tested with an external battery which were also good (and now released so I can move the car if needed). Part of the fault isolation was to pull C135 connector on the ABS module and cables off the motors to verify cable continuity.
Hooked up a scan tool and received 2007/2008-13 for the EPB circuits. Also could not perform the maintenance mode procedure to release the EPB. After trying to set and release the EPB a couple times with no consistent operation, the EPB was set for both rear wheels and would not release. Daughter's 2014 Fusion Titanium threw an EPB warning light.
